User's Manual
Forward
Left Sideward Right Sideward
Forward/Backward
Backward
9
E01003 USER MANUAL
8. Return To Home
In GPS positioning mode, you can press the " " One Key Return button to return the aircraft. Do not control any functions during
the process of return or ascent. When the aircraft is landing, you can toggle the joystick to control it to land on your desired location.
When the aircraft is returning to home point, long press the " " One Key Return button to exit auto return mode.
Notes: As for the return to home point as precise as possible, please ensure the GPS positioning function has
been turned on (the aircraft’s rear light turns solid green) to record the aircraft’ s position and choose an
area away from obstacles before its takeoff.
With the GPS positioning mode turned on, it will automatically enter auto return to home mode if the remote
controller loses control.
With the auto return to home mode enabled, if the aircraft flies below 30 meters of altitude, the aircraft will
automatically ascend to 30 meters before returning to home point. However, if the aircraft flies over 30
meters of altitude, the aircraft will return to home point at the current altitude. Do not control other functions
during the process of return. And ensure there are no obstacles in way of return to avoid accidents.
After the aircraft lands and the propellers stop rotating, long press the power switch for at least 2 seconds to turn off the aircraft and
the remote controller.
Warning: Please stay away from aircraft until propellers stop rotating completely.
9. Pair the Aircraft with the Remote Controller
The aircraft has already paired with the remote controller by default. If the remote controller has been replaced, please pair again
complying with the following steps:
1) Switch on the drone and the remote controller.
2) Unlock your mobile phone, enter the menu “Settings-WLAN” to view the Wi-Fi network list, among which you can see “Drone-
xxxxxx” (xxxxxx consists of characters and numbers) of the drone and “Controller-xxxxxx” of the remote controller (xxxxxx consists
of characters and numbers). Please take down the serial number of the remote controller for further reference.
3) Click the Wi-Fi network of the drone to connect.
4) Enter the APP interface and click “…” in the top right corner to enter the menu.
5) Find “RC Paired” and click “Pair”.
6) A dialogue box will pop up. Type in the serial number of the remoter controller in the box and click “Pair” to conrm.
7) Navigate your mobile phone to “Settings-WLAN” again to check the serial numbers of the drone and the remote controller. If the
two serial numbers are correct, the pairing will be successful, with the drone’s rear lights turning ashing green or solid green.