Specifications
深圳市创荣发电子有限公司
SHENZHEN C&D ELECTRONICS CO., LTD.
Page 9/42
wet or mark of liquid infiltration shall be observed
on the PCB (circuit patterns side).
7. 打开上壳观察内部。在电路的那一面,不能有
水渍如板子的痕迹.
4.11
盐水测试
Salt
water test
检查遥控器的外观是否异常.字符标志应清晰可
见。Check the appearance of the remote
control for abnormalities. Character
markings should be clearly visible.
用浸过 20%食盐水的棉球或软布,轻轻擦拭遥控器
表面(包括按键字符部位)50 次。Gently wipe the
surface of the remote control (including
the key characters)50 times with a cotton
ball or soft cloth soaked in 20% salt water.
4.12
食用油测试
Edible
oil test
检查遥控器的外观是否异常字符标志是否清晰。
Check the appearance of the remote
control for abnormalities. Character
markings should be clearly visible.
将食用油(花生油、豆油或菜籽油)用滴管滴在遥
控器表面三个不同部位(包括字符、图形符号部
位),每部位滴 0.1mL,面积约 1c ㎡,1h 后用软
布擦干。The edible oil (peanut oil, soybean
oil or rapeseed oil) is dripped on the
surface of the remote control with a
dropper at three different parts (including
character and graphic symbol parts).
Each part drops 0.1ml, covering an area
of about 1c ㎡. After 1hour, dry with a soft
cloth.
4.13
贴纸测试要求
Label
test
贴纸无脱落、翘起,撕下时无残留. No shedding
and warping. No residue when torn off.
震动、跌落、高温高湿后查看标签测试结果. Check
label results after vibration, drop, high
temperature and humidity test.
4.14
PE
袋 测 试 要 求
.
PE bag test
1. 印刷油墨不能脱落.The printing ink should not
fall off.
2. PE 袋不可开裂破损. PE bags shall not be
cracked or damaged
1. 环境温度 30±5 度,#EF74 橡皮擦测试:负重:
500gf/cm²/ 速度:30 次/分, 橡皮擦擦拭区域:
30mm ,次数 15 次 . Ambient temperature:
30±5 ℃ , #EF74 eraser test: load:
500gf/cm/speed: 30 times/min, eraser wipe area:
30mm, 15 times
2. 反复拆装袋 5 次,PE 袋不能有裂开破损. Open
and pack the bag repeatedly for 5 times, PE bag
cannot be cracked or damaged.
4.15
卡 键 测 试 Button
test
不卡键 Button bounce well.
用手指按压键的任何点. Press any point on the
key with your finger