Specifications

深圳市创荣发电子有限公司
SHENZHEN C&D ELECTRONICS CO., LTD.
Page 8/42
4.9
Cross cut test
百格测试
->a square SHOULD not cling to the tape.
胶带上不能粘碎屑
measure force of adhesion, count number of
pealed section in cutting area.
测量附着力，计数切割区域内已剥落的截面数。
Should cut lines (11×11) at intervals of 1mm with
cutting knife,
用刀每隔 1mm 割一条线（11X11）
Paste the scotch tape on cutting area and peel it
off quickly at an angle of 45°
在被割的区域贴上透明胶带并且在 45°角快速撕
下胶带.
4.10
Waterproofing test
防水测试
Pour water 200ml on the keys, specially the gap
between key and key-hole for 3 seconds,
afterward wipe water immediately, check the
operation. Next, after disassembly, check the
surface of PCBA.
3S 钟倒 200ml 水在按键上，尤其是按键孔位置，
立即把水擦干，然后检查操作。
接下来，拆开遥控器，检查 PCBA 表面。
->RCU SHOULD operate and the surface of
PCBA SHOULD not get be wet.
遥控器要正常工作，PCBA 表面不能湿。
1. Place the RCU on a horizontal surface with
the top cover facing up. Do not insert batteries.
1. 遥控器正面朝上平放，不要装电池。
2. Fill a beaker with 180ml of water (Colored by
orange ink), then pour the water over the keys of
unit evenly from 5cm height to the top of unit.
2.用烧杯装 180ml 的水（水用橘色墨水染上色），
然后把水从 5cm 的高度倒到遥控器表面。
3. Leave the units 1 minute after pouring 180ml
of water.
3. 倒完 180ml 水之后把遥控器放置 1 分钟。
4. Wipe water on the surface of the units without
pressing keys.
4. 把遥控器表面上的水擦掉，不要按按键。
* Do NOT tilt or reverse during wiping.
擦拭时不要倾斜或者倒置遥控器。
* Do NOT wipe water between keys and top
case.
不要擦上壳或者遥控器按键之间的水。
5. After wiping, leave the units 96 hours to dry.
※ Temperature 25 ℃ ± 5, humidity 50% ± 10
5. 擦拭后，把遥控器放置 96 小时干燥
※温度是 25 ℃ ± 5，湿度是 50% ± 10
6. Insert batteries. All keys & MIC shall work
properly.
6. 插入电池。所有按键和 MIC 要正常工作。
7. Open top case to observe inside the unit. No