Specifications

深圳市创荣发电子有限公司
SHENZHEN C&D ELECTRONICS CO., LTD.
Page 15/42
分功能、灵敏度) 测试完成后行为模式正常,无误触,反应慢。The rising temperature is 45 degrees
above zero,60% humidity (keep the temperature for 3 hours or so and check the function of the
remote control, feel of the keys and the function and sensitivity of the touch control part), the
behavior mode is normal after the test is completed, without accidental trigger or slow reaction.
5.6
Thermal shock test
热冲击测试
Conduct the heat shock(-20+60) cycle 100+/-5cycle. Measure perfprmance after leaving
under standard condition for 1 hour
进行冷热冲击测试(-20+60) 100+/- 5 个循环。在常温中静置 1 小时后测试功能。要能正常工作
->The RCU SHOULD operate normally.
5.7
盐雾测试 Salt Spray
test
1.将试件置于盐雾柜内,并在温度 35℃,盐雾浓度 5%之测试条件下,保持 24 小时
2以上测试完成后将测试样品于常温静置 2 小时; 1Place the
specimen in the salt spray cabinet and keep it for 24 hours under the test conditions of 35 and 5%
salt spray concentration
2.After completion of the above tests, the test samples should be left at room temperature for 2
hours.
检查 Check
1.金属电镀件表面镀层应无明显发暗,无鼓泡、脱落、龟裂、露底等缺陷;
2.铝或铝合金镀阳极氧化膜表面无白色腐蚀物;
铜或铜合金镀镍+铬表面无浅绿色腐蚀物;
锌或锌合金镀镍+铬表灰黑物及 1. The
coating on the surface of metal electroplating parts shall be free from obvious darkening, bubbling,
peeling, cracking, and other defects;
2. No white corrosion on the surface of anodic oxidation film of aluminum or aluminum alloy plating;
Copper or copper alloy nickel + chromium plating surface without light green corrosion;
Zinc or zinc alloy nickel + chromium plating surface without black corrosion and bubbling;
6、产品认证要求 Certification
序号 No.
项目 Item
规格 Specs
6.1
ROHS
符合 ROHS 2.0 要求。
6.2
FCC ID
6.3
IC
6.4
BQB