Specifications
深圳市创荣发电子有限公司
SHENZHEN C&D ELECTRONICS CO., LTD.
Page 13/42
*Discharge with the battery removed
不带电池测试
>If the RCU recovers by reinsertion of the battery, it
is DESTRUCTION.
如果遥控器从新装上电池后才回复,这就是损毁。
>If the pairing memory is erased, it is
DESTRUCTION.
如果配对信息擦除,这就是损毁。
>If RCU reconnects automatically after
disconnecting with the TV, it is MALFUNTION.
如果遥控器于电视机断连后又从新自动回连,这是
故障
5、环境测试 Environmental Test
序号
No.
项目 Item
测试要求 Test Requirements
5.1
温度变化试验
Temperature change
test
遥控器在装电池,不包装的状态下,放入具有室温的试验箱内,试验箱内的温度以 1±0.5℃/min 的降温速
率(5min 内的平均速率)降至-10±3℃试验箱内达到稳定温度后,恒温 3H,然后试验箱内的温度再以
1±0.2℃/min 的升温速率(5min 内的平均速率)升高到 40±2℃等试验箱内达到稳定温度后,持续 3h,然后
试验箱内的温度再以 1±0.2℃/min 的降温速率内(5min 的平均速率)降至试验室环境温度值以上,构成一
个试验循环依次连续进行 20 个试验循环试验结束后,且试验箱内的温度达到稳定的试验室环境温度后,
取出遥控器。20 个试验循环试验结束后,且试验箱内的温度达到稳定的试验室环境温度后,取出遥控器
检查遥控器的各项功能是否正常。The remote control is put into a test box at room temperature with
battery and without packaging. The temperature in the test box is cooled at a rate of 1±0.5℃/min
(5min)) at an average rate of the drop to 10 + 3 ℃ - test after reaching a stable temperature in the
oven, constant temperature for 3 h, and then test the temperature in the cabinet to 1 plus or minus
0.2 ℃ / min heating rate (5 min) at an average rate of increase to 40 plus or minus 2 ℃ after test
the reach a stable temperature in the cabinet, for 3 h, and then test the temperature in the cabinet to
1 plus or minus 0.2 ℃ / min in the cooling rate (5 min) at an average rate fell to a lab environment
temperature above, form a test cycle in turn for 20 consecutive test cycle after the test, and test the
temperature in the cabinet after reaching stable laboratory environment temperature, take out the
remote control Device. After the cycle of 20 tests is completed and the temperature in the test box