Specifications

深圳市创荣发电子有限公司
SHENZHEN C&D ELECTRONICS CO., LTD.
Page 11/42
4.22
Drop test
(Abnormal height)
跌落测试(非正
常高度)
Drop the RCU onto concrete- or asphalt- floor
from 150cm height, about the weakest planes of
RCU in the Normal height Drop test
将遥控器最弱那面从 150cm 高度跌下,跌在混凝
土或者沥青地面上
->SHOULD be free from abnormality such as
scattering of broken cabinet etc., or damage on
connected set.
不可以有遥控器结构破损,遥控器零件散落等连接
性的问题发生
And the edges of broken cabinet should not be
sharp. *But, the damage on function can be
accepted.
断裂的结构件边缘不能是锋利的。
遥控器功能性问题可以接受。
4.23
Drop test in
packing
带包装的跌落测试
->SHOULD meet the electrical and mechanical
performance mentioned in a specification.
需要满足在规格书中提到的规格
Drop a carton box filled with RCUs from the
specified height.
跌落测试规格如下:
Height : 80cm (<10kg)
65cm (10kg=< <20kg)
*2 corners2 角), 2 ridges2 脊), 6 planes6
面)
4.24
包装运输试验:振动
试验 Package
transportation
test: vibration
test
没有功能失效或材料损坏. No functional failure
or material damage.
整箱包装的振动测试:将产品放置在包装箱内。
此包装箱放置在符合以下条件的振动装置上:频
率:7Hz 加速度:1.05g 在三个轴方向上测试,
30min Vibration test for FCL
package: place the product in the package.
Place the box on a vibrating device that meets
the following conditions: frequency: 7Hz
acceleration: 1.05g test in three axis
directions, each direction lasts for 30min.
4.25
裸机振动 Single
vibration.
a 功能正常
b 无主要机械不良
c 静动态电流满足规格. No functional failure or
material damage.
成品机固定在振动台上,然后按以下条件
试:Fix the finished machine on the shaking table
and then test according to the following
conditions:
*频率范围 frequency range: 10~55Hz
*振动幅度 vibration amplitude:1.5mm
* 振动周期 vibration cycle:1 分钟
(10~55~10Hz)
*振动方向 vibration direction: X,Y&Z 方向
*振动时间 vibration time:每个方向 2 小时(总