Use Instruction

13
trembling, shivering).
9.5 Blood pressure measurement
1) In the state of shutdown or standby, press the [Start/Stop] for starting up, it will start measurement
automatically, and the CUFF will inflate automatically.
* When the CUFF starts to inflate, the Monitor will start to work automatically. In the process of inflation,
the Monitor will also detect the pulse, so please do not move your Arm in the whole measurement process,
and remain static throughout the process. The Arm will feel the CUFF extrusion, and this is a normal
phenomenon of inflation.
* If the LCD appear an error code or error, please refer to the clause “ERROR AND FAULT
INSTRUCTIONS” for troubleshooting.
2) Stop automatically after full inflation, and start to detect the pulse rate.
In the measuring process End of the measurement
Note: This pictures in the measurement interface are only for reference.
a) After the measurement is completed, the Monitor will display your blood pressure valve and pulse
rate number.
b) If the monitor has stored results, the LCD will display the last one. If no result has been stored, “--”
will appear on LCD.
c) After the measurement is completed, take off the CUFF, press the [Start / Stop] button, and shut
down manually.
d) If no button is pressed, then the system will be shut down automatically after about 60 seconds.
e) For the model with backlight, if no button is pressed, the backlight will be shut down automatically
about 6 seconds later.
Note: