Use Instructions
Table Of Contents
- SMART EYE MASSAGER
- Instructions for Use
- 1Introduction
- 2Cation, Safety and Warning
- 3Inside the Package
- 4User Interface
- 5Product Specification
- 6Transportation and Storage Conditions
- 9Operation
- 10Clean and Disinfection
- 11MainTenance, Repair
- 12Troubleshooting tips
- 13Disposal Treatment Statement
- 14Certificate
- 15Limited Warranty
h) Drop, collision and bending, etc. may reduce the performance of the
battery; if the battery is found abnormal, such as packaging damaged
and battery pack deformation, etc. do not use these batteries.
12 Troubleshooting tips
Problem
Cause
Correction
No power or no
working.
Too lower power.
Charge the massager
before turning it on.
The massage was too
weak.
Low power.
Charge the massager.
No indicator light.
1. The Type-C port is
faulty or connector
disconnected.
2. The charger failed.
1. Replace the Type-C
port or repair the
connector.
2. Replace with a good
charger.
13 Disposal Treatment Statement
The product manufacturing date can be seen on the nameplate of the
massager, and the product life is 3 years.
WARNING: Do not throw away batteries with uncontrolled daily
waste.
CAUTION: Dispose of the massager, components and optional
accessories according with applicable national or regional regulations.
Unlawful disposal may cause environmental pollution.
The marking in this manual that the batteries in this product should be
disposed with household trash at the end of its working life. If the batteries are
not disposed of properly, the substances included can cause harm to human
health and the environment. Please follow environmental laws and guidelines
for proper waste disposal.
14 Certificate
The manufacturer submits the massager samples to a third-party laboratory for
testing. And the laboratory tested the product provided by the applicant
according to the follow test methods and pass. According to the test results,
the product conforms to RED Directive (2014/53/EU) issued by the European
Commission. It is possible to use CE marking to demonstrate the compliance
with the directive.
Essential
requirement
Applied standards
Art.3.1(a)
Health
EN 50663: 2017; EN 62479: 2010
Art.3.1(a)
Safety
EN 62368-1:2014 + A11: 2017
Art.3.1(b)
EMC
ETSI EN 301 489-1 V2.2.3 (2019-11); ETSI EN 301