Specifications

FCC RF Radiation Exposure Statement
FCC RF exposure compliance,The radiated output power of your tablet
is below the FCC radio frequency exposure limits. Nevertheless, it
should be used in such a manner that the potential for human contact
is minimized during normal operation of your tablet.
CAUTION:
The total radiated energy from the antennas connected to the installed
wireless modules conforms to the FCC limit of the SAR (Specific
Absorption Rate) requirement, regarding 47 CFR Part 2 Section 1093,
when the computer was tested in either conventional notebook or
tablet computer orientations. To know the location of transmission
antennas for the Wireless LAN/Bluetooth combo module and the
wireless WAN module, see “ Locate the UltraConnect TM wireless
antennas” in the user Guide.
Simultaneous use of RF transmitters. Your tablet is approved for
simultaneous use of the integrated wireless LAN/Bluetooth combo
module.
Make sure of the following conditions when you use any other external
wireless option device:
• When you use any other RF option device, you are requested to confirm
that the device conforms to the RF Safety requirement and is approved to use
for your tablet.
• You must follow the RF Safety instructions of wireless option devices that
are included in the user manual of the RF option device.
• If wireless options are prohibited to use in conjunction with another
transmitters, you must turn off all other wireless features in your tablet.
Radio Frequency interference requirements.
When you use a wireless LAN module in the 802.11 a/n/ac transmission
mode, note that high power radars are allocated as primary users of
the 5250 to 5350 MHz and 5650 to 5850 MHz bands. These radar
stations
can cause interference with and/or damage this device.
REGULATORYSTATEMENT
29