Quick Installation Guide Model:BL-WR2000 300Mbps Wireless N Router
1.Connecting the device Note: Please use wired network connections only to configure the Router. 1 Connect the WAN port on your Router to the Modem's LAN port with an Ethernet cable. (If there is no Modem, please use the incoming cable directly into the router's WAN port). Internet Cable/DSL Modem 1 Wireless N Router 2 Connect your computer to the Port labeled 1~4 on the Router with an Ethernet cable.
4 Check the router's LED indicator lights display status is the same as described. Power: Solid light SYS : Flashing WPS: Flashing WLAN: Flashing ~ LAN:Flashing or solid light if the corresponding port is connected WAN:Flashing or solid light Note: If the LED indicator light display abnormal, please check whether the connection is correct.
2.Configuring the device Note: First of all, please configure your computer's IP address to automatically obtain, if not clear, please refer to FAQ3. 1 Login Open your web browser,input 192.168.16.1 in the address field and press Enter. about:blank - Microsoft Internet Explorer Address 192.168.16.1 Go A dialog box will prompt you for the User name and Password. Enter the default values and click OK.
2 Internet Paremeters Configuration This page will then display Quick Setup Network Wireless Firewall Virtual Server QOS Quick Setup Qucik Setup DHCP (Auto Config) Select a connection type Static Mode (fixed IP) PPPOE (ADSL) Back Next Cancel Apply Click Next How to select a connection type? Note: 1.Make sure the cable is securely plugged into the WAN port before detection. 2.
3 Wireless Settings Configuration This page will then display Quick Setup Create a unique and easy-to-remember name for your wireless network.You can also keep default settings without the device being affected. Network Wireless Firewall Virtual Server QOS Quick Setup Qucik Setup Network name(SSID) B-LINK_90E09F Security WPA2-PSK AES WPA Algorithms Select Security and WPA Algorithms, Suggest to choose “AES”.
3.Troubleshooting FAQ1: What should I do if I forget the user name and password? (How to restore the router 's configuration to its factory default settings.) Answer: If you forget the user name and password, the only way to solve this problem is to reset the router. Press and hold the RESET button on the rear panel for 5 to 8 seconds before releasing it. Hold for 5 to 8 seconds FAQ2: What can I do if I cannot access the Internet? 1.
For Windows XP OS Click Network Connections Right-click Local Area Connection Click Properties Double-click Internet Protocol (TCP/IP) 7
For Windows XP OS Select Obtain an IP address automatically Select Obtain DNS server address automatically Click OK Click OK 8
For Windows 7 OS Go to Start > Control Panel, you will then see the following page.
For Windows 7 OS Double-click Internet Protocol Version 4 (TCP/IPv4) Click OK Select Obtain an IP address automatically Select Obtain DNS server address automatically Click OK 10
For Windows 7 OS Click OK 11
For Windows 8 OS Press the Keyboard WIN( )+X to popup the menu on the Win8 Desktop, then select Control Panel Click View network status and tasks Click Change adapter settings 12
For Windows 8 OS Right-click Ethernet Click Properties Double-Click Internet Protocol Version4(TCP/Ipv4) 13
For Windows 8 OS Select Obtain an IP address automatically Select Obtain DNS server address automatically Click OK Click OK 14
is the registered trademark of Shenzhen BILIAN Electronic CO . ,Ltd.All the products and product names mentioned herein are the trademarks or registered trademarks of their respective holders 2012 All Rights Reserved. http://www.lefen.com Ver 2.