User's Manual
9 10
(2.7-4.0kPa) lower than the blood pressure measured in the hospital. It is important
to know your normal blood pressure when you are calm at home.
When the cuff is higher than the heart during measurement. If the table or platform
on which the blood pressure monitor is placed too high, causing the cuff to be higher
than the heart, the measured blood pressure value is low.
Have you taken antihypertensive drugs? People who take antihypertensive drugs
will cause high blood pressure when they lose their effectiveness. Please accept
the doctor's guidance.
Is the cuff wrapping position correct? If the cuff position is misplaced, the arterial
signal cannot be captured, and the blood pressure measured is too high. Please
follow the "wind upper arm" page.
Is the cuff wrapping too loose? If the cuff is wrapped too loosely, the compression
force cannot be transmitted to the artery, so the measured blood pressure value is
higher than the actual value. There should be no gap between the arm and the cuff,
please wrap the cuff tightly.
Is the posture correct during measurement? Measuring postures such as bending
over, sitting cross-legged, bending down on a sofa or low table, etc. will cause
abdominal pressure or the position of the arm lower than the heart and raise blood
pressure.
Why is the blood pressure measured at home lower than the blood pressure
measured at the hospital?
We often feel nervous when taking measurements in the hospital. Because we
are in a stable mood when measuring at our home, sometimes it is 20-30mmHg
GasolineThinnerVolatile
oil
Use memory and clear memory function
The blood pressure monitor can automatically store measurement results, and can
store 2*99 groups of measurement data. If more than 99 sets of measurement data
have been stored, the oldest set of measurement results will be deleted and the new
measurement results will be recorded.
1)View memory
In the power-on state, short press the 0(025<button to query the stored
measurement data. long press to view continuously. The default is to query the
memory value of "User 1". the 212))button at this time is used for exit.
2)Clear memory storage data
,QVKXWGRZQVWDWHORQJSUHVV0HPRU\EXWWRQGRQRWOHWJRZKHQ8VHURU8VHU
LVGLVSOD\HGZKHQ&/LVGLVSOD\HGWKHPHPRU\RIWKHFXUUHQWXVHUZLOOEH
FOHDUHG
Be sure to observe the items in the manual and other correct usage methods.
If you do not comply, our company will not be responsible for quality.
Maintenance
•Please clean the blood pressure monitor frequently
•If the main body is dirty, please wipe it with a dry soft cloth
•If the main body is extremely dirty, dampen a soft cloth with water or neutral
detergent, wring it out thoroughly, and then wipe the main body.
•Do not wipe with oil, thinner, gasoline, etc.
•Do not wash or wet the cuff.
•Do not get water to enter the main body.
Do not place the blood pressure monitor in the following places:
•Places exposed to direct sunlight, high temperature, humidity, dust, and corrosive
gases.
•Places that are inclined, vibration, or impact.
•Places where chemicals or corrosive gases are stored.
When not in use for a long time (more than 3 months), please remove the battery
and store it in the box.
Maintenance and storage
Q&A
Storage method