User's Manual

9
4.2 OSD MENU Adjustments and Settings
The following table shows all adjustment and setting menus.
Main Menu Sub Menu Reference
Input Main Input VGA / DVI
Brightness 50
Contrast 50
Sharpness 12
Aspect Ratio Full / Full Aspect / Native / User /
5:4 / 4:3
Image
Mode Select Overlap selection
Color temp 5500K, 6500K, 7500K, 8500K, 9300K,
10000K, USER
Gamma 3.0, 2.8, 2.6, 2.4, 2.2, 2.0, 1.8
OSD Position Center / Top Left / Top Right
Bottom Left / Bottom Right
OSD Language English / Chinese
Auto Scan Input On /off
Setup
Factory Reset
Reset factory value
Auto Adjust
H-position 31
V-position 31
Clock based on input signal
VGA
Phase
FW version Version information
Main Format
Status
Main Input Display current input
4.3 Screen Adjustment
Screen adjustments for the LCD monitor should be used in suppressing screen flickering
and also for adjusting the screen to its proper position. There is only one correct position for
each display mode. It is also recommended to use the OSD Menu function when first
installing the display or whenever changing the system.
Note: Allow the LCD monitor to stabilize for at least 20 minutes before making image
adjustments.Making Adjustting must be VGA signal.
Adjustment Procedure
1. Adjust by <Auto Adjust> menu in the OSD Menu.
To automatically adjust the clock, phase, screen position and resolution.
Note:
The Auto sizing function is intended for use on the computer running Windows. It may not
work properly when the computer is running on MS-DOS (Not windows) or the background
color for the "wall paper" or "desktop" pattern is set to black.
If the appropriate screen cannot be made by using the Auto adjustment button, adjust the
screen through the following procedures.