User's Manual

8
3. CABLE CONNECTION
3.1. Before Connecting
Before connecting your monitor to the computer, change the display screen settings
(Resolution and frequency) in accordance with the charts below.
Note:
- The lower display modes like 640x480, automatically enlarge to the maximum display
mode (1280x1024), and some lines of the characters may become fuzzy.
- When your computer and display support VESA DDC, the suitable resolution and the
refresh rate are set by just plugging your display into the computer without any
manual settings.
3.2. Connecting the Cables
Note: Be sure that the power switches of both the computer and the monitor are OFF.
DVI D-SUB USB AC IN
USB cable connection:
Plug the USB cable to the USB connector in the rear of the PC system, and plug the other
end to the monitor;
DVI cable connection:
Plug the DVI signal cable to the DVI connector in the rear of the PC system, and plug the
other end to the monitor. Secure cable connectors with screws.
VGA cable connection:
Plug 15-pin VGA signal cable to the VGA connector in the rear of the PC system, and
plug the other end to the monitor. Secure cable connectors with screws.
Power cable connection:
1. Connect the power cord to the AC input on the rear of the monitor.
2. Plug the power cord into the AC Plug, and plug the other end of the cord into a power
outlet