User's Manual

7
3. CABLE CONNECTION
3.1. Before Connecting
Before connecting your monitor to the computer, change the display screen settings
(Resolution and frequency) in accordance with the charts below.
Note:
- The lower display modes like 640x 480, automatically enlarge to the maximum
display mode (1920 x 1080), and some lines of the characters may become fuzzy.
- When your computer and display support VESA DDC, the suitable resolution and the
refresh rate are set by just plugging your display into the computer without any
manual settings.
3.2. Connecting the Cables
Note: Be sure that the power switches of both the computer and the monitor are OFF.
AUDIOIN DISPLAYPORT DVI D-SUB DC IN
Audio cable Connection:
Plug the audio cable to the audio port in the rear of the PC system, and plug the other
end to the monitor;
Note: AUDIO IN port is valid for DVI and D-SUB only.
Display Port cable connection:
Plug the Display Port signal cable to the Display Port connector in the rear of the PC
system or other signal source, and plug the other end to the monitor.
DVI cable connection:
Plug the DVI signal cable to the DVI connector in the rear of the PC system, and plug the
other end to the monitor. Secure cable connectors with screws.
VGA cable connection:
Plug 15-pin VGA signal cable to the VGA connector in the rear of the PC system, and
plug the other end to the monitor. Secure cable connectors with screws.
Power cable connection:
1. Connect the adapter power cord to the DC input on the rear of the monitor.
2. Plug the power cord into the DC adapter, and plug the other end of the cord into a
power outlet