User's Manual

4.3. OSD MENU Adjustments and Settings Screen Adjustment

Screen adjustments for the monitor should be used in suppressing screen flickering and

also for adjusting the screen to its proper position. There is only one correct position for

each display mode. It is also recommended to use the OSD Menu function when first

installing the display or whenever changing the system.

Note: Allow the monitor to stabilize for at least 20 minutes before making image

adjustments.

Making adjustment must be VGA signal.

Adjustment Procedure

1. Adjust by <Auto Adjust> menu in the OSD Menu.

To automatically adjust the clock, phase, screen position and resolution.

Note:

The Auto sizing function is intended for use on the computer running Windows. It may

not work properly when the computer is running on MS-DOS (Not windows) or the

background color for the "wall paper" or "desktop" pattern is set to black.

If the appropriate screen cannot be made by using the Auto adjustment button, adjust

the screen through the following procedures.

2. Adjust by using <VGA> menu in the OSD Menu.

(1) Vertical bars appear on the screen

Use the <Clock> adjustment.→

Select the <Clock> and eliminate the vertical bars by using the UP and Down of the

Control buttons.

Do not continuously press the Control buttons, as the adjustment value will change

quickly and make it difficult to locate the most suitable adjustment point. If the

horizontal flickering, blur or bars appear, proceed to <Phase> adjustment as follows.

(2) Horizontal bars appear on the screen.

Use the <Phase> adjustment.→

Select the <Phase> and eliminate the horizontal flickering, blurring or bars by using the

Right and Left buttons.

Note: Horizontal bars may not completely disappear from the screen depending on the

computer.

(3) The screen position is incorrect.

Use the <→ H-Position> or <V-Position> adjustment.

The <H-Position> or <V-Position> adjustment moves the image to the correct

position. Select <Position> and adjust the position by using the Up and Down buttons.

If vertical bars of distortion appear after finishing the <H-Position> or <V-Position>

adjustment, return to <Clock> adjustment and repeat the previously explained

adjustment procedure. (Clock Phase <→→H-Position> or <V-Position>)