User's Manual

Page 19 of 26
digital signals which is lower than
1280 x 1024 can be adjusted. Analog
signals can be adjusted in all
supported resolution.
Negative figure is adjusted to get
softer image and positive figure is
adjusted to get sharper image. The
user should individually adjust the
filter depending on the application.
Input
Source
DVI-D
DP
VGA
Select the active input source
priority.
If you call this OSD menu, the current
source is displayed. If current source
is inactive (NO sync) and, it will auto
search other port.
Auto-Color ON / OFF Automatically get input signal
match with the monitor
Auto-Configure ON / OFF Automatically adjust the image display
settings.
Auto Adjust
(Analog only)
Execute The selected auto functions are
executed.
Note: The quality of the function
depends on the applied picture
contents. To get better effect it is
recommended to apply full screen
picture and including white and dark
contents.
Horizontal
position
0 … 255 Adjustment of OSD horizontal position
Vertical
position
0 … 255 Adjustment of OSD vertical
position
Background 0 … 12 Select the OSD background transparency
LED ON/OFF Setting the status of the operation
LED.
English
OSD Settings
Language
中文
Use the "Language" menu to select the
language of the OSD menu.
English is the default.
While in the English menu state the ”
中文” font means to select to Chinese
menu. And while in Chinese menu state
the “English” font means to select to
English.
Information Firmware version
OSD version
Config version
Power saving
Input Source
LUT
Working hours
Current display status can be
informed。
Service Level 2 Settings in this menu must only be carried out by service person*