User's Manual

PMP-3880 PARTS CHECKLIST
6
6. Remote access card
S
E
T
D
A
Y
CODE
ERASE
O
G
M
H
O
U
R
MIN
UTE
S
T
O
P
ANS
O
N/OFF
Charge
R
i
n
g
s
3
r
5
r
t
s
P
L
A
Y
A
N
S
O
N
/
O
F
F
I
N
U
S
E
M
a
i
l
1
M
a
i
l
2
M
a
il
3
M
a
il 4
P
A
G
E
M
E
M
O
1. Handset 2. Base
4. AC power adapter
7. Quick start card
3. 7-foot line
cord for desk use
QUICK START GUIDE
PMP-3850
1. Connect the telephone line cord to the "LINE"
jack and to a telephone outlet.
2. Connect the AC power adapter to the 9V DC
jack and to an AC outlet.
Note: Use only the supplied AC power adapter.
Do not use any other AC power adapter.
Connect the AC power adapter to a contin-
uous power supply. Place the phone close
to the AC outlet so that you can plug in the
AC power adapter easily.
SETTING UP THE BASE
TEL LINE DATA
9VDC
300mA
1. Slide the battery pack up into the compar tment at
the bottom of thehandset. Make sure that the end
of the battery with the contacts is inserted first.
2. Snap the battery compar tment cover into place.
3. Place the handset on the charging cradle. The IN
USE/CHARGE LED on the charging cradle will light
when the handset is properly making contact with
the charge terminals.
4. IMPORTANT: Charge the battery pack for at least
12 hours before using the handset the first time.
INSTALL THE BATTERY
1. Pick up the handset and press T.
2. Wait until you hear a dial tone and then dial the number you wish to dial.
Tip: It is also possible to pre-dial the number,by dialing the number prior to press-
ing the T key. The number displayed will be dialed once T is pressed.
3 When you are finished talking, press the T key or place the unit back
into the base to end the call.
MAKING CALLS
Insert
battery
with this
label
facing
handset
back
9. Belt-Clip
5. 10-number
memory card
8. Ni-MH battery pack
1. Dial the answering machine
phone number.
2. Enter the three-digit remote
code after the OGM has
finished playing.
3. If the correct code is
entered (within 6 digits), the
phone will beep and you
can now access it remotely.
4. When finished, hang up.
This symbol is to alert you to important operating or servicing instructions that may appear in
the user's manual. Always follow basic safety precautions when using this product to reduce the
risk of injury, fire, or electrical shock.
When using this product, basic safety precautions should always be followed to reduce the risk of fire, electric shock
and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Use only with class 2 power source DC 9V 500mA.
4. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth
for cleaning.
5. Do not use this product near water; for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement
or near a swimming pool.
6. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.
7. Slots and openings in the cabinet back or bottom are provided for ventilation. To protect it from overheating, these openings
must not be blocked or covered. The openings should never be blocked by placing the product on the bed, sofa, rug, or other
similar surface. This product should never be placed near or over a radiator or heat register.This product should not be placed
in an enclosed environment unless proper ventilation is provided.
8. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by animals or
persons walking on it.
9. Do not overload wall outlets and extension cords as this can result in risk of fire or electrical shock.
10. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short
out parts that could result in a risk of fire or electrical shock. Never spill liquid of any kind on the product.
11. To reduce the risk of electrical shock, do not disassemble this product. Instead take it to a qualified service person when
service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect
re-assembly can cause electrical shock when the appliance is subsequently used.
12. Unplug all cords and refer servicing to qualified service personnel under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating instructions. Adjust only those controls covered in
the operating instructions. Improper adjustment of other controls may result in damage and require work by a qualified
technician to restore the product to normal operation.
13. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock
from lightning.
14. Do not use a telephone to report a gas leak in the vicinity of the leak.
IF YOUR PRODUCT UTILIZES BATTERIES,THE FOLLOWING ADDITIONAL PRECAUTIONS SHOULD BE OBSERVED:
1. There is danger of the battery exploding if it is incorrectly installed. When inserting the batteries into this product, the proper
polarity or direction must be observed. Reverse battery insertion can cause charging that may result in leakage or explosion.
2. Use only the type and size of batteries specified in the users manual.
3. Do not dispose of batteries in a fire. The cells may explode. Check with local codes for possible special disposal instructions.
4. Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be
toxic if swallowed.
5. Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets and
keys. The battery or conductor may overheat and cause burns.
6. Do not attempt to recharge the batteries with or identified for use with this product. The batteries may leak corrosive
electrolyte or explode.
7. Do not attempt to rejuvenate the batteries provided with or identified for use with this product by heating them. Sudden
release of the battery electrolyte may occur causing burns or irritation to eyes or skin.
8. When replacing batteries, all batteries should be replaced at the same time. Mixing fresh and discharged batteries could
increase internal cell pressure and rupture the discharged batteries.
9. Remove the batteries from this product if the product will not be used for a long period of time (several months or more) since
during this time the batteries could leak, damaging the product.
10. Discard "dead" batteries as soon as possible since they are more likely to leak in a product.
11. Do not store this product, or the batteries provided with or for identified use with this product, in high temperature areas.
12. If your product uses a rechargeable battery, charge the battery(ies) only in accordance with the instructions and limitation
specified in the User Manual.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
5