User's Manual

Tone/Pulse Switch
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or
Pulse by setting the switch on the
bottom of the base unit.
Note: Changes to the switch position
during a call do not take effect
until the call has ended.
Tip: If you are unsure of the proper dialing mode, make a trial call with the dial
mode setting to TONE. If the call connects, leave the switch as is (TONE
mode), otherwise, set to PULSE.
NOTE: Pulse dialing works for direct dialing and redialing only, not for memory
dialing.
Handset Volume
Adjust the receiver volume of the handset using the
volume control switch on the right side of the
handset.
Note: Ringer options can be selected on the
handset when programming setup functions
(see page ??).
TELEPHONE SETUP
18
Wall Mounting
The PMP-3880 telephone may be installed onto two screws (not included)
fastened into the wall. When installing screws into plasterboard walls, use wall
anchors (not included) to ensure that the screws remain secure. Insert the
screws into the wall leaving 3/16" of each screw extending out from the wall.
See the wall mount template on page ?? to properly space the screws in the
wall for mounting. The PMP-3880 is not compatible with mounting on a
standard telephone wall plate.
Wall Mounting Instructions:
1. Remove the handset from the
base.
2. Adjust the base to the wall mount
position.
3. Plug the supplied 7-foot telephone
cord into the
Line jack on the
telephone.
4. Connect the telephone line cord
to the wall jack.
5. Insert the AC adapter into the
9V
DC jack on the top of the base.
6. Run the cables down through the
cable channel to allow for flush
wall mounting.
7. Slip the telephone base onto the wall, lining up the wall mounting holes over
the screws. Slide the telephone base down so it is firmly in place.
8. Return the handset to the telephone base.
9. Plug the other end of the AC adapter into the AC outlet.
TELEPHONE SETUP
17
RINGON /RINGOFF
ICM/ANNC
TONE /PULSE
Tone/Pulse
Switch
HI MID LOW