User's Manual

Tone/Pulse Switch
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or Pulse by
setting the switch on the bottom of the
base unit.
Note: Changes to the switch position
during a call do not take effect until
the call has ended.
Note: Pulse dialing works for direct dialing
and redialing only, not for memory
dialing.
Tip: If you are unsure of the proper dialing mode, make a trial call with the dial
mode setting to
TONE. If the call connects, leave the switch as is (TONE
mode), otherwise, set to PULSE.
Handset Volume
Adjust the receiver volume of the handset
using the volume control switch on the right
side of the handset.
Note: Ringer options can be selected on the
handset when programming setup
functions (see page 22).
Base Ringer On/Off
Adjust the base ringer volume using the
RINGER switch on the right side of the base,
near the rear of the phone. Select between Hi
ringer, Low ringer, and ringer Off.
TONE /PULSE
16
TELEPHONE SETUP
Tone/Pulse
Switch
Wall Mounting
The PMP-3860 telephone may be installed onto two screws (not included)
fastened into the wall. When installing screws into plasterboard walls, use wall
anchors (not included) to ensure that the screws remain secure. Insert the
screws into the wall leaving 3/16" of each screw extending out from the wall.
See the wall mount template on page 49 to properly space the screws in the
wall for mounting. The PMP-3860 is not compatible with mounting on a
standard telephone wall plate.
Wall Mounting Instructions:
1. Remove the handset from the
base.
2. Adjust the base to the wall mount
position.
3. Plug the supplied 7-foot telephone
cord into the
LINE jack on the
telephone.
4. Connect the telephone line cord
to the wall jack.
5. Insert the AC adapter into the
9V
DC jack on the top of the base.
6. Run the cables down through the
cable channel to allow for flush
wall mounting.
7. Slip the telephone base onto the
wall, lining up the wall mounting
holes over the screws. Slide the telephone base down so it is firmly in place.
8. Return the handset to the telephone base.
9. Plug the other end of the AC adapter into the AC outlet.
15
TELEPHONE SETUP
HI MID LOW
Ringer
ON/OFF
Volume Control
Switch