User's Manual

Tone/Pulse Switch
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or Pulse
by setting the switch at the back of the
base unit (may require use of a pen,
pencil, or other small device to move
the switch).
Note: Changes to the switch position
during a call do not take effect
until the call has ended.
Tip: If you are unsure of the proper dialing mode, make a trial call with the dial
mode setting to
TONE. If the call connects, leave the switch as is (TONE
mode), otherwise, set to PULSE.
Handset Ringer Hi/Low/Off
Adjust the handset ringer volume using the RINGER
switch on the right side of the handset. Select
between
Hi ringer volume, Low ringer volume, and
ringer Off.
14
TELEPHONE SETUP
Wall Mounting
The PMP-3815 telephone may be installed onto two screws (not included)
fastened into the wall. When installing screws into plasterboard walls, use wall
anchors (not included) to ensure that the screws remain secure. Insert the
screws into the wall leaving 3/16" of each screw extending out from the wall.
See the wall mount template on page 25 to properly space the screws in the
wall for mounting. The PMP-3815 is not compatible with mounting on a
standard telephone wall plate.
Wall Mounting Instructions:
1. Remove the handset from the
base.
2. Adjust the base to the wall mount
position (see illustration).
3. Plug the supplied 7-foot
telephone cord into the
LINE jack
on the telephone.
4. Connect the telephone line cord
to the wall jack.
5. Insert the AC adapter into the
9V
DC jack on the top of the base.
6. Run the cables down through the
cable channel to allow for flush
wall mounting.
7. Slip the telephone base onto the wall, lining up the wall mounting holes over
the screws. Slide the telephone base down so it is firmly in place.
8. Return the handset to the telephone base.
9. Plug the other end of the AC adapter into the AC outlet.
13
TELEPHONE SETUP
Tone/Pulse
Switch
Ringer
Off Low Hi