User's Manual

The PMP-3815 will store up to 10 speed dial numbers.
Storing Phone Numbers
1. With the handset in the idle state, press l.
The handset will beep.
2. Dial the number you wish to store (up to 16 digits).
Note: Press R/PAUSE to insert a dialing pause
into the number. The pause lasts for 4 seconds
and uses one digit of the 16 digits available.
3. Press l.
4. Press the dial pad key (0-9) for the location where
you wish to store the number. The handset will give
a confirmation tone.
Note: If you make a mistake the handset will give
three quick beeps to let you know that the
number was not stored.
Making Speed Dial Calls
1. Push T. The handset In Use LED will glow steadily when a connection is
made. Wait until you hear a dial tone.
2. Press l
and the dial pad key location where the number is stored.
3. When you are finished with your call, press T
, or place the handset back
on the base.
Note: Be sure to check that the line is not in use by another extension.
Deleting a Stored Number
1. With the handset in the idle state, press l. The handset will beep.
2. Press R
and then press l. After each press the phone will beep.
3. Press the dial pad key location where the stored number that you want to
delete is located. The handset will give a confirmation tone.
SPEED DIALING
18
Making Calls
1. Pick up the handset from the base and press T.
The LED on the handset will glow steadily when a
connection is made. Wait until you hear a dial tone.
2. Dial the number you wish to dial.
3. When you are finished talking, press the T
key or
place the unit back into the base to end the call.
Note: The IN USE light on the handset will flash when
the line is active.
Receiving Calls
Make sure that the handset ringer switch is not set to
“Off” in order to receive incoming calls.
When you hear the phone ring:
1. If the handset is in the base, lift the handset from the base. The handset will
turn on. There is no need to push the T
key if the unit is on the base when
the call comes in.
2. If the handset is off the base, you will need to press T
to answer the call.
3. When you are finished, push T
or place the handset back on the base.
Additional Options
BASIC OPERATION
To: Do This:
Redial the last number Press T. Wait for dial tone and then press R.
Adjust the volume in the Adjust the Volume Hi/Mid/Low switch on the upper left
earpiece side of the handset, until the desired volume is reached.
Switch to temporary tone Press the *
key after the phone is in use. The phone
dialing will remain in tone dialing mode for the duration of the call.
Receive a call waiting call Press E
to go to the new caller.
Press E
again to go back to the original caller.
17
In Use/
Low Batt.
Pause
MEM
2.4 GHz
Redial Key
Temporary
Tone Key
Talk Key
In Use LED
Pause Key
Flash Key
In Use/
Low Batt.
Pause
MEM
2.4 GHz
Redial Key
Memory Key
Talk Key
In Use LED