User's Manual

FCC NOTICE

Warning: Adjustment to this unit or replacement of any transmitter

component (crystal, semiconductor, etc.) to this unit that could result in a

violation of the rules.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits for are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation, If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to

which the receiver is needed.

Consult the dealer or an experienced radio/TV technician for help.

If shielded cables or special accessories are required for compliance, a

statement must be included which instructs the user to employ them, eg.

Shielded cables must be with this unit to ensure compliance with the

Class B FCC limits.

This device complies with Part 15 of the FCC Rule. Operation is

subject to the follow two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.