User's Manual

Problem Solving

Technical Information

Problem Solving Section

For your assistance, we have listed below a few common problems.

Phone does not work, check the following:

1. BASE UNIT is plugged into a power source.

2. HANDSET is charged.

3. TONE/PULSE Select Switch is in the right position.

4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK.

Range of phone limited, check the following:

1. BASE UNIT is centrally located in your residence.

2. BASE UNIT is not located near appliances.

No dial tone, check the following:

1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and

TELEPHONE LINE CONNECTION JACK.

2. BASE UNIT is plugged into a power source.

Received signal flutters or fades, check the following:

1. BATTERY PACK in the HANDSET is fully charged.

2. HANDSET is not too far from the BASE UNIT.

Interference on reception, check the following:

1. Noise may be picked up from electrical products in the home or electrical storms. Generally,

this noise is a minor annoyance and should not be interpreted as a defect in your system.

(See Technical Information on page 30).

Excess static, check the following:

1. Check to see that the ANTENNA is not touching another metal object.

If after pressing the button, you receive three “beeps” and no dial tone, check the

following:

1. BASE UNIT is plugged into a power source.

No connection between the HANDSET and the BASE UNIT, check the following:

1. Did you register your HANDSET to the BASE UNIT? (See page 24 for registering the

HANDSET(S).)

NOTE:

If none of the telephones in the house are working, disconnect one set at a time to verify that

none of the phones are causing the problem. If you still have a problem after doing

this, and your telephone still does not work, please contact your local phone company.

TALK

DSST~MAN~ATC.qxd 4/24/2003 5:15 PM Page 36