User's Manual

07110A-1
8
99251 Ver. 1.0
Page:8 ENGLISH VERSION
99251 Ver. 1.0
Page:8 ENGLISH VERSION
L (LOCK) Button - Press and hold to Lock the
buttons.
INSTALLATION
Battery Installation
NOTE: Prior to removing the battery cover, remove
the belt clip (see section “Removing The Belt Clip”).
1. Press and pull down battery cover.
2. Install four "AAA" type batteries (not included),
following the polarities marked in the battery
compartment.
3. Reinstall the battery cover.
NOTES:
When the FRS is not being used it has a built-in
power saver for maximum battery life.
Remove the batteries if the unit will not be used
for a long period of time.
Battery charging
To charge the unit using “AAA” Ni-MH rechargeable
batteries, insert the round connector of the AC/DC
adaptor into the CHG/MIC jack on top side of the unit.
WARNING
DO NOT CHARGE THIS UNIT USING AN AC/DC
ADAPTOR WITH REGULAR “AAA” ALKALINE
BATTERIES INSTALLED.
ONLY USE THE AC/DC ADAPTOR WITH “AAA” Ni-
MH RECHARGEABLE BATTERIES.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-
zinc), or rechargeable batteries.
Installing the Belt Clip