User's Manual

Problem Solving Section

For your assistance, we have listed below a few common problems.

Phone does not work, check the following:

1. BASE UNIT is plugged into a power source.

2. HANDSET is charged.

3. TONE/PULSE Select Switch is in the right position.

4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK.

Range of phone limited, check the following:

1. BASE UNIT is centrally located in your residence.

2. BASE UNIT is not located near appliances.

No dial tone, check the following:

1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and

TELEPHONE LINE CONNECTION JACK.

2. BASE UNIT is plugged into a power source.

3. If you had a power failure or had unplugged the BASE UNIT, replace the HANDSET on

the BASE UNIT for 2 to 5 seconds to reset the system.

Received signal flutters or fades, check the following:

1. BATTERY PACK in the HANDSET is fully charged.

2. HANDSET is not too far from the BASE UNIT.

Interference on reception, check the following:

1. Noise may be picked up from electrical products in the home or electrical storms.

Generally, this noise is a minor annoyance and should not be interpreted as a defect

in your system. (See Technical Information on page 41).

2. Choose an alternate channel using the button on the HANDSET.

Excess static, check the following:

1. Check to see that the ANTENNA is not touching another metal object.

If after pressing the button, you receive three “beeps” and no dial tone, check the

following:

1. BASE UNIT is plugged into a power source.

2. If you had a power failure or had unplugged the BASE UNIT, replace the HANDSET on

the BASE UNIT for 2 to 5 seconds to reset the system.

Problem Solving