User's Manual

Using the Remote Instruction Code
1. Dial your telephone number.
2. Listen to or bypass the OGM in the PRIMARY MAILBOX.
3. Enter your Remote Access Code. If the announcement does not stop, enter the
Remote Access Code again.
4. The Answering System will request that you enter the Instruction Code or
press “*” button for help.
A. If you do not know the Instruction Code, press “*” button immediately. The
Answering System will announce the Instruction Codes. Otherwise, if a
command is not received by the Answering System within 10 seconds, it will
signal 3 “beeps” and hang up.
The following is the Remote Instruction Code Help Menu:
Instruction Codes
To Playback Message Press “2.”
To Repeat Message Press “1.”
To Skip Message Press “3.”
To Stop Press “8.”
To Playback Announcement Press “5.”
To Turn Answering Machine ON or OFF Press “6.”
(Press “1” for MAILBOX 1, Press “2” for MAILBOX 2, Press “3” for MAILBOX 3,
and Press “4” for MAILBOX 4. Otherwise, if you did not press the desired
MAILBOX # location within 2~3 seconds, the memo will be automatically
recorded in the PRIMARY MAILBOX.)
To Erase Message Press “9.”
To Record MEMO or Announcement Press “0.”
(To record a message press “2”, to record announcement press “5”)
(Press “1” for MAILBOX 1, Press “2” for MAILBOX 2, Press “3” for MAILBOX 3,
and Press “4” for MAILBOX 4. Otherwise, if you did not press the desired
MAILBOX # location within 2~3 seconds, the memo will be automatically
recorded in the PRIMARY MAILBOX.)
To Change Mailbox Press “#.”
B. Press the corresponding number of the Instruction Code you wish to activate.
You don’t have to listen to the entire Instruction Code Help Menu before giving a
command. You may enter the desired Instruction Code Number at any given
time.
Answering System Operation
35