User's Manual

Cordless Telephone Operation

Receiving Calls

1. When the phone rings, the display will

show “RING.” If you have Caller ID, the

display will show the Caller ID

information after the first ring.

2. With the HANDSET off the base, press

the button.The Call Timer starts to

count.

3. To end your conversation, either press the button or place the HANDSET on

the BASE UNIT. If you place the HANDSET on the BASE UNIT CHARGE CRADLE,

you activate the AUTOMATIC STANDBY feature.

NOTE: The Call Timer will start to count once you press the button.

Minutes

Seconds or Channel (Press

the DEL/CHAN button to

display the channel.)

Call Timer Display

Preparing for Use

Before you can use your cordless telephone, you must charge the HANDSET for 12

hours. Failure to do so will require recharging of the BATTERY PACK more often.

1. Place the HANDSET on the BASE UNIT for 12 hours.

2. After 12 hours, remove the HANDSET from the BASE UNIT.

Before you can use your cordless telephone, you must charge the HANDSET

for 12 hours. Failure to do so will require more frequent charging of the

BATTERY PACK. See page 27 for more information on the BATTERY PACK.

NOTE:

Depending on the frequency of use, once the HANDSET is fully charged, it remains

functional for approximately 4 hours of continuous use and approximately 5 days when

the HANDSET is off the BASE UNIT in STANDBY mode.

TALK

IMPORTANT

In order to utilize the Caller ID feature, you

must subscribe to Caller ID service from

your local telephone company.

TALK