User's Manual

4
CHARGING AND CHECKING BATTERY LEVEL
★
Please charging before the first time using!
Please use USB charger with the following parameters (this product can be charged with mobile phone charger
or computer USB interface, please check the following parameters before charging):
Input: 100-240V, 50/60HZ
Output: 5V 1000 mA (or 300mA/500 mA)
Charging the remote transmitter: Connect the USB cable, the battery icon on screen will keep flowing when
charging, and stop when it is fully charged.
Charging the receiver:
1. Open the rubber cover and connect the charger.
2. When charging, the receiver green indicator is flashing. The receiver cannot receive signals at this time.
3. After the receiver is fully charged, the green LED indicator will automatically turn off.
Check the Receiver Battery Inventory:
When the receiver is in power-on state, quickly press the power button once could check the receiver battery
inventory:
Receiver beeps 4 times, representing 75%-100% battery left;
Receiver beeps 3 times, representing 50%-75% battery left;
Receiver beeps twice, representing 25%-50% battery left;
Receiver beeps once, representing 0 %-25 % battery left.
Low battery warning:
When the battery is lower than 20%, the green indicator flashes once per second, indicating that the receiver is
already in low battery, please charge it in time.
When going out to train your dog, please check the receiver battery power and charge it if the indicator flashes
once per second.
Warm Notice:
1. The remote transmitter and receiver should be charged for 3 hours at least before the first time using.
2. The functions cannot be used when the receiver is charging.
3. The green indicator flashes once per second when the receiver battery is low, please charge it in time.
4. To make sure the product can be used continuously, please charge the device once a month if it is not often
use.
5. After fully charged, please cover the rubber on USB interface well to avoid water getting inside at later using
which will cause damage.