User's Manual

3
HOW TO PAIR THE REMOTE AND RECEIVER
1. Press the “CH” button to choose a signal channel you want to use.
2. Short press the power button to turn on the receiver, after hearing "beep" sound once, the receiver is
under working status, then the green LED indicator will flash once in 5 seconds. 5 minutes later, the device will
enter into sleep mode if there is without any operation, the green LED indicator will flash once in 10 seconds；
Press the power button 1 second, after hearing "beep" twice, the device is turned off.
3. When the receiver is off, press the power button for 2 seconds, when hearing long "beep" from the receiver,
and the green LED indicator flashes rapidly, it has entered into the signal pairing state, and the flashing lasts for
15 seconds. At this time, you have to press the function button of the remote transmitter (vibration
/static shock /sound ) during the flashing period, and the signal will be connected.
4. The pairing will be closed if we didn't press any function button within 15 seconds during the indicator
flashing state. Please pair it again if required.
5. If you have 3 receivers, please press the "CH" button to switch the signal channels and connect.
6. You can choose channel 1, 2 or 3 to connect to the receiver individually, to send training commands to each
dog, or you can open all three channels at the same time, then the connected receivers can receive signals at
the same time, to interact with multiple dogs(For example, when there are multiple dogs at competition, you
can send commands to them at the same time)..
Note: Dog training collar set with 1 receiver is usually connected with channel 1 by factory
default setting, and if with multiple receivers please kindly pairing them according to this connection method.
Warm Notice
1. Please keep in mind the signal channel you are using and do not change it at will, otherwise the remote
control command will not be received!
2. The device will work only when the receiver and the remote transmitter signals have been connected.
Please kindly connect the signal according to the connecting method at manual when using it for the first time.
3. Both the remote transmitter and receiver are with energy saving design. The remote transmitter will enter
the sleep mode if there is no operation within 20 seconds, but press any button on remote transmitter will
resume it work immediately.
4. If you press and hold any function buttons like vibration/static shock and warning sound for a long time by
accident, the receiver will stop the job after it continues working for 10 seconds.