User's Manual

2
BUTTON INTRODUCTION
1
Static shock button: Press this button and the
receiver will emit static shock signal; press the +/- button
will reduce and increase the static shock level.
2
Tone button: Press this button and the receiver will
beep; Press the +/- button will reduce and increase the
sound level.
3
Signal channels switch button: With 3 channels to
switch, the remote can connect the 3 receivers at the
same time and also individually. Please follow the
instructions below to connect the signal between remote
transmitter and receiver according to the correct
operation. The factory default channel is .
4
Flashlight button: With 2 modes, strobe light and
strong light mode. Press it once, the light is in strong light
mode; press it again, it will enter into strobe mode, flash
twice a second; and press it the third time, the light is
turn off. Then cycle. Note: The strobe mode can attract
the attention of dogs and effectively interact with pets.
5
Screen lock button: Press the button for 2 seconds to
lock the screen, same for unlock. When the screen is
locked, all the buttons will not work.
6
Vibration button: Press this button and the receiver
will emit vibration signal, press the +/- button will reduce
and increase the vibration level.
7
The +/- button: Reduce and increase the level of
functions like beep, vibration and static shock. There are
100 levels can be adjusted.
8
Power button: To open and close the receiver; Long
press it for 2 seconds will enter into connecting mode,
the green indicator light will flash.
9
Indicator light: It will flash when charging, pressing
the function button or connecting. The color is green.
10
Electrode column: Install a pair of screw
caps(Electrode Contact Points) suitable for different dog,
can effectively conduct static shock for dog training.