Instruction Manual

6
2. Plug the included power adapter into the car cigarette lighter socket, the
indicator will light up meaning power is on.
3. Connect the power adapter and the dash cam, and route the excess cable
alongside the interior trim for better looking.
4. Start your car, the camera will automatically power on, check the lens angle and
coverage, make sure all functions works well before going on the road.
Function Description
Power on/off:
1. Power on: The device will automatically enter video recording mode when press
the Power Button or connect the device to car charger.
2. Power off: Press and hold the power button until “Goodbye” appears on
the screen.
After the car breaks down, the device will automatically power off when the car
charger stops supplying power.
Video Recording mode:
1. Power on: The device will automatically enter video recording mode when press
the Power Button or connect the device to car charger.
 The Red Indicator on front of unit will illuminate and blink.
 The recording icon will change to red and blinking, it means the
device is recording video normally.
2. Press the power button will stop recording.
 The Red Indicator on front of device will stop blinking.
 The Red icon “ ” will disappear, it means the device has stopped
recording.
3. Press the power button again will start the device recording again.
Photo Mode:
1. When the device is in the standby state (when recording is stopped), press the
menu button about 2 seconds until the photo icon appears on the top