User Manual

Power Input
Video Output
Twist to lock
connectors
Video Input
Video & Power Cable
Connect this to your DVR
Power Splitter
connects here
Power Output
Power Adapter
connects here
Power Splitter
Power Adapter
Video & Power Cable
connects here
Connect to a spare
power outlet
Bullet Camera
US B
Internet
4
3
2
HDMI IN 1
HDMI IN 2
Power Adapter
1
2
3
4
5
HDMI Cable
Ethernet Cable
Dome Camera
2
1
3
VGA 12V INVIDEO IN
AUDIO
OUT
LAN&USB
7
8
5
6
3
4
1
2
AUDIO IN
B A
PTZ
Digital Video Recorder
Connect the video output on the video
& power cable to each camera input
(VIDEO IN) on your DVR. Twist the
connection to lock it in place.
Connect the supplied Ethernet cable
to the Ethernet port (LAN) on your
DVR then connect the other end to a
spare port on your router.
Connect the supplied mouse to the
bottom USB port.
To copy your video recordings and to
perform a firmware upgrade, connect
a storage device such as a USB flash
drive (not included) to the top or front
port.
Your DVR is designed to ventilate air
to keep it at an optimal temperature.
Keep your DVR free from obstructions
to allow it to ventilate properly.
Connect the supplied HDMI cable
to the HDMI port on your DVR then
connect the other end to a spare HDMI
input on your TV.
Press the A/V button on your TV’s
remote to select the HDMI input your
DVR is connected to.
Connect the supplied power adapter’s
power connection to the power input
(12V IN) on your DVR first (this will
minimise sparking). Connect the
power adapter to a spare power outlet.
The bullet camera has three points
of articulation. Use an Allen key to
loosen the hex screw then adjust to
the position you want. Tighten the hex
screw again to secure in place.
What are the additional connections for?
Audio In Port: For connecting a microphone (the
microphone must have its own power source).
Audio Out Port: For connecting to a stereo or amplifier.
This is not required when using the HDMI port.
PTZ Port: For connecting RS-485 compatible devices.
VGA Port: Connect this to your monitor with a VGA
input (VGA cable not supplied). This is not required
when using the HDMI port.
Mounting and aiming a dome camera
1) Loosen the three screws located at the base of the
camera then remove the bracket cover and dome cover.
2) Using the appropriate screws for the surface you are
mounting to, screw the bracket to fasten.
3) Replace the dome cover and bracket cover.
4) The camera can be aimed in almost any direction. After
you’ve finished adjusting the camera’s viewing position,
tighten each screw to lock the position in place.
Positioning the bullet camera
To avoid damage, don’t position the camera without
loosening the hex screws first.
1) This enables you to rotate the camera left or right.
2) This enables you to position the camera up or down.
3) This enables you to rotate the camera stand left or
right.