User's Manual

10 11 12
13 14 15
16 17 18
10
Welcome!
Lets get started.
QH48_1550H181013E | © Swann 2013
Connect the mini HDMI cable (supplied)
to the HDMI input on the device, and
connect the other end to a spare HDMI
input on the TV.
Insert the provided Micro-SD
card into the TF slot, which is
located next to the power but-
ton, until it clicks into place.
Connect the power connection on the
camera to the power extension cable.
Connect the DC 12V power supply to the
other end of the power extension cable.
QH470KIT191213E | © Swann 2014
Peel off the plastic cover
that is protecting the LCD
display.
US B
Intern et
Ethern et
4
3
2
HDMI IN 2/MHL
HDMI IN 1(DVI)
Connect the DC 5V power supply to the
power input on the device. There will be
a label on each power supply denoting
which end is plugged into what device.
An Ethernet connection is required for
Internet access when the device is in AP mode
(see Setup Wizard for more information).
Connect the Ethernet cable (supplied) to
the LAN connection on the device, and then
connect the other end to a spare port on your
router.
Connect the mini USB cable here.
This is used to update the firmware
when available.
Reset Button
LAN
What are the additional connections for?
Reset - If the device becomes unresponsive,
use a paperclip to reset.
Audio Out - For connecting headphones or
speakers.
Adjust the antenna
so they are placed
vertically.
The LAN connection is mainly used for
configuration to your Wi-Fi network.
FCC warning: The transmitter must not be co-
located or operated in conjunction with any other
antenna or transmitter. This equipment complies
with the FCC RF radiation exposure limits set forth
for an uncontrolled environment. This equipment
should be installed and operated with a minimum
distance of 20cm between the radiator and any part
of your body.