User's Manual

13
SwannView Link: Device Settings
Display: Channel Settings
Channel Name (Check Box): Whether the channel’s name will be displayed on screen or not.
Channel Name: The title you’d like to give that camera.
Record Data: Whether the overlays (Channel Name, Date and so on) will be recorded onto the video with
your images.
Position Settings: Select the position of the channel name and record date labels that are overlaid on the
screen.
Mask (Check Box): Turns the masking function on or off.
Mask (Setup): Creates a black privacy overlay which masks part of your images. Will affect recordings.
Display: Output
Resolution: Set the screen resolution to output to your monitor.
Transparency: How transparent you want the menus to be.
Mouse Sensitivity: Adjust the sensitivity of mouse movements.
Dwell Time: Select how long channels will be displayed when using auto-sequence mode.
Audio: Enable or disable the audio.
Recording: General
Encoding Parameter: Choose from the main-stream or sub-stream to configure.
Main Stream: The way the device will internally process and record video.
Sub Stream: The way the device will encode and send video to a remote device.
Record Audio (Check Box): This function is not supported by the camera(s) supplied with the NVR.
Resolution: How many pixels (little dots) make up your image.
Frame Rate: How many images per second the device will capture.
Max. Bitrate: The maximum size that your video files will be. The higher this is set, the better recordings
will look - however, they’ll also fill the memory card faster.