Product Manual

8
Remote control instructions
7
Remote control operation:
1） Remote control battery display: When the main button is pressed, the main button will flash, flashing
four times is about full power, flashing three times is about 75% of the power, flashing two times is
about 50% of the power, flashing about 25% of the power.
2）Follow mode: Start the trunk power switch and the remote control power switch, click on the puppy
pattern on the remote control to open the follow mode, the box will follow closely behind, please be
careful not to block the follower module on the trunk. The follow mode is not recommended in the case
of a large number of people. Short press the follow button to turn on the non-obstacle mode follow,
long press the follow button to start the obstacle avoidance mode follow.
Whether to open the obstacle avoidance division: follow the button flashing to avoid obstacle
avoidance, and the long light is to avoid obstacles.
Main button
Riding button
Remote control pairing:
Press the main button and the ride button at the same time, press and hold 1S until the buzzer emits a
drop, drop, .......... slow cycle sound, the LED of the ride button will flash at the same frequency, and the
main button The LED is long bright.
Then the user aligns the main button with the hole of the motor board. If the pairing is successful, the
buzzer will slam the drip 5 times, and the LED will flash 5 times, then return to normal. The buzzer in the
cabinet is also drastically dripping 5 times.
If it is not successful, then the drop of the remote control, the slow cycle will continue to ring, and the LED
will also strobe. The buzzer and LED are automatically turned off after 2 minutes. End the pairing.
The remote control has been paired successfully at the factory and does not need to be paired again:
Turn on the remote control, please wait until the main button flashes before proceeding.
follow ride
Main button