User's Manual

www.art-tech.com
16
If oil aircraft, please connect the power of receiver to other channel at first, and then plug it
to BATT after frequency bind.
The process of frequency bind for 2.4GHz R/C system
(
Receiver with two antenna)
4. Pulling out the short-circuit plug.the indicator
light turns flash. The rece iver get into working
mode.
2. Press the switch for frequency bind, then
turn on the transmitter's power.
5.
rebound.The transmitter get into working mode.
the indicator light will light.which means that the
radio system can work normally now.
Press frequency bind switch again to get it
3. If the frequency is successful, the
indicator light will light.
bind
1.
Receiver in the position of BATT.
the ESC to receiver for electricity supply,
wihch results to the indicator light glitter.
Plug the short- circuit plug into the
Connect