User's Manual

Operating voltage
Current drain：
Range(Height)：
Adjacent channel rejection：
：4.8V~5.2V
≤40mA
Weight：12g
dimension：44mm*23mm*15mm
Channels: 6 Channels
≥350m
≥-85dBm± 16kHz
Receiver
Function
1.
2.
3.
4.
5.
6.
Undercarriage
Specifications
Rudder
Throttle
Elevator
Aileron
For operating helicopter
Operation for aeroplane
Pitch
B.
Battery/Bind
1.
2.
3.
4.
5.
6.
Rudder
Throttle
Elevator
Aileron
Pitch
B.
Battery/Bind
Gyro gain
Signal
+
-
Signal
+
-
To make the receivers work normally, the input DC power should be stable and meet some requirements. The
input power is for receiver circuit and for servos.
The input voltage should be between 4.8V ~ 6V.
The working current is 0.25A of the receiver plus the current of servos.
Usually there are three ways for the receiver power supply:
1. Separate battery pack for the receiver.
2. Electronic speed controller with BEC (Battery Eliminate Circuit).
3. Dedicated receiver power supply distributor (UBEC).
If the flight model using this set of remote control device needs large manipulation force when flying, that is, in
case the servos may bear greater reaction and the work current of the servos is large, you need to pay more
attention to the receiver power supply stability in particular. Electricity supply equipment with good
performance is proposed to choose.
Power supply for the receiver
www.art-tech.com
12
RECEIVER
ER61-2.4GHz
CH
RECEIVER
ER61-2.4GHz
CH