User's Manual

7
www.art-tech.com
functions of the RC device
ETB62A-2.4GHz has a variety of flight mode.It can be used for all ordinary aeroplanes,delta
wing aeroplanes,gliders, coaxial helicopters, general helicopter and CCPM helicopter models,
and so on.
A: ordinary aeroplanes
Settings: Set switch U(1) to ACRO,Set switch P to NOR
Use: 1.by adjusting fine-tuning knob A,the turning range of servos for CH1,CH2 and CH4 can be
adjust form 20 % to 10 0%
2.Small Rate can be choosen by setting the switch F to 1.
3.switch A is for CH6 flap and CH5 collapsible landing gear at the same time. Flap can be
adjusted by fine-tuning knob B form 0% to 100%
4.by setting the switch set Q,the reverse setting of CH1,CH2,CH3,CH4 and CH6 can be adjusted.
B: delta wing aeroplanes
Settings: Set switch U(1) to ACRO,Set switch P to MIX
Use: 1.by adjusting fine-tuning knob A,the turning range of servos for CH1,CH2 and CH4 can be
adjust form 20 % to 100%
2.Small Rate can be choosen by setting the switch F to 1.
3.switch A is for CH6 flap and Ch5 collapsible landing gear at the same time. Flap can be
adjusted by fine-tuning knob B form 0% to 1 00%
4.by setting the switch set Q, the reverse setting of CH1, CH2, CH3, CH4 and CH6 can be
adjusted.
C: general helicopter and coaxial helicopters
Settings: Set switch U(1) to HELI, Set switch P to NOR. For coaxial helicopter mode, set Dual
Rate(D/R) to 1.
Use: 1.CH3 and CH6 mixing for pitch control, PIT and PLT can be tuned by knob A and B
2.The switch F is to choose Dual Rate（100% / 70% ）for CH1, CH2 and Ch4.
3.The switch A is for 3D mode, it is used for the stunt mode
4. by setting the switch set Q, the reverse setting of CH1, CH2, CH3, CH4 and CH6 can be
adjusted.
Note: When use coaxial helicopter mode, do not use 3D mode.
D: CCPM helicopters
Settings: Set switch U(1) to HELI, Set switch P to MIX.
Use: 1.CH1, CH2, CH3 and CH6 are mixed to achieve control for CCPM helicopter, PIT and
PLT can be tuned by
knob A and B
2.The switch F is to choose Dual Rate（100% / 70% ）for CH1, CH2 and CH4.
3.The switch A is for 3D mode, it is used for the stunt mode
4.by setting the switch set Q, the reverse setting of CH1, CH2, CH3, CH4 and CH6 can be
adjusted.
 EBT62A-2.4GHz has the unique cordless trainer function. For details, please refer to (The
using of trainer function).

Other function of transmitter
Servo reversing switches
If the direction of servo operation is not the same as the model, adjust the reversing switches to
reverse the direction.
The lower position is the normal setting and the upper position is the reverse setting.