User's Manual

TRANSMITTER

www.art-tech.com

Always test the digital proportional R/C set

before use. Any abnormality in the digital

proportional R/C set, or model, may cause a

crash. Before starting the engine, check that

the direction of operation of each servo

matches the operation of its control stick. If a

servo does not move in the proper direction,

or operation is abnormal, do not fly the

plane.

We offer Mode I and Mode II two types of transmitter for selection. Customers

should choose one according to their individual needs.

You will need 8 AA batteries for operating the transmitter.

Please do not press the frequency bind switch when the Transmitter at work

mode, or else your device will not work!

If the indicator of the transmitter or the receiver flashing once every two

seconds after turn on the power please bind the frequency of the transmitter

and the receiver again.

Low battery voltage alarm function.

The transmitter will emit a high-pitched tone if the battery voltage gets too low.

The transmitter can not work properly if the

frequency bind button is pressed down

neglectfully. In this case, The transmitter

and the receiver must be bind again.

More details , ease refer to the process

of frequency bind for 2.4 GHz R/C system.

Please do not turn on several RC devices and

bind them at the same time, bind only one set

of RC device at one time. The RC device should

not be stay in bind state for a long time.

Do not fly the plane near the house,

road,electrical wire and airport.