User's Manual

www.art-tech.com

The operating direction, neutral position, and steering angle of each servo are

adjusted.

ADJUSTMENTS

5. Fly the plane and trim each servo.

4. After all the linkages have been connected, recheck the operating direction,

throw, etc.*Before flight, adjust the aircraft in accordance with the kit and engine

instruction manuals.

3. Check the engine throttle (speed adjustment) linkage. Change the servo horn

installation position and hole position so that the throttle is opened fully when

the throttle stick is set to HIGH (forward) and is closed fully when the throttle

stick and throttle trim are set for maximum slow (backward position and lower

position, respectively).

2. Check the aileron, elevator, and rudder neutral adjustment and left-right (up-

down) throw. Check that when trimmed to the center, the servo horn is

perpendicular to the servo and check the neutral position of the fuselage control

surfaces (aileron, elevator, rudder, etc.). If the neutral position has changed,

reset it by adjusting the length of the rod with the linkage rod adjuster.

When the throw is unsuitable (different from steering angle specified by the kit

instruction manual), adjust it by changing the servo horn and each control

surface horn rod.

ADJUSTMENT PROCEDURE

Before making any adjustments, set all the SERVO REVERSER switches on the

front of the transmitter to the lower (NOR) position. (Switch the switches with a

small screwdriver, etc.) Turn on the transmitter and receiver power switches and

make the following adjustments:

1. Check the direction of operation of each servo If a servo operates in the wrong

direction, switch its SERVO REVERSER switch. (The direction of operation can

be changed without changing the linkage.) * Note that the direction of the aileron

servo is easily mistaken.

The jack on the left side of the transmitter can be connected to the computer via a

simulation cable , the beginner can practise flying on the computer. This learning

process can make the green hand be familiar with the operation and reduce the

damage, please refer to the specific CD-ROM for more information.

The using of computer-controlled interface