User's Manual

www.art-tech.com

1 1

Before using trainer function, you should first bind the frequency of the master(teacher)

transmitter to the receiver, adjust the same aircraft to respectively.Before entering

into the next step, please make sure the reverse switches and mode settings are set

correctly.

Make sure that the master transmitter and the receiver have been bound (frequency bind)

The using of trainer function

 the binding process of the master transmitter and the slave transmitter

3. Wait Until the indicator of the

master transmitter turns red and

the slave transmitter turns green,

which means the binding of the two

transmitter has been completed,

you can use the trainer function

now.

1. Press the frequency bind button

of the master transmitter, turn on

the power, the indicator flashes.

2. Press the frequency bind button of the slave

transmitter, put the slave near the master. turn

on the power of the salve, the indicator flashes.

Note: using the trainer function, the mater transmitter and the slave transmitter should be in

the same mode. VA,VB is controlled by the master transmitter. Before flying, the reverse

switches of the two transmitter must be correct,and then fine-tuning knob should be adjusted

to achieve the effect that when switching control, there are no changing in servo positions.



When holding the TRN switch of the master transmitter, the indicator of the salve transmitter

flashes , the slave transmitter can now control the plane; If holding the TRN switch of the

slave transmitter, the indicator of the master transmitter flashes , this is only used for the slave

to send prompt signal to the master.

using of trainer function

Red light on

Green light on