User's Manual

www.art-tech.com
12
The process of frequency bind for 2.4GHz R/C system
Place the transmitter and the receiver close to each other within one (1) meter.
If oil aircraft, please connect the power of receiver to other channel at first, and then
plug it to BATT after frequency bind.
1. plug the short- circuit plug into the Receiver
in the position of BATT. Connect the ESC to
receiver for electricity supply, which results to
the indicator light glitters.
2. Press the frequency bind button, then
turn on the transmitter' s power.
6. The indicator light turns bright again,
which means that the radio system can
work normally now.
3. the indicator light of the receiver will light,
which indicates that the frequency bind is
successful.
4. Unplug the short-circuit, the indicator
light glitters.
5. Press frequency bind button again to get it
rebound. After the indicator light flashes for a
few seconds, it turns green, the transmitter
get into working mode.