User Manual

More Security, More Convenience www.apexis.com.cn / www.apexis.cc
Shenzhen Apexis Electronic Co., Ltd Tel: [phone] Fax: [phone]
4
●Mounting bracket X1
NOTE: Please contact us immediately in case of any damaged or short of contents.
1.3.1 Front View
1Sensitive Hole: For light sensitive
2 Infrared LED: For night vision.
3 LENS: CMOS sensor with fixed focus lens. (Default is 6mm, 3.6mm optional)
4 Microphone: Build-in microphone
5 Wireless Antenna: WI-FI Antenna
1.3.2 Rear/Side Panel
Figure 1.2
LAN: RJ-45/10-100 base T
Power: DC 5V/2A power supply
I/O PINS: 1 Output A 2 Output B 3 Alarm input 4 Input (GND)
Network Light: Green LED turn on when connect to the network, yellow LED will blink when data transferred
Audio Output: The jack is used to plug external speaker
RESET BUTTON: Press and hold the RESET BUTTON for 15 Seconds, then the IPCAM will be reset back to
the factory default Parameter. (Please keep the power on when do RESET)
1.3.3 Bottom /Back View
Figure 1.3
Original Apexis IPCAM have some stickers at the bottom/back, such as MAC address sticker, QC sticker etc.
If your camera does not have these stickers, it may be a clone one, clone Apexis IPCAM could not use the
original firmware and obtain our good after sale service.