Instruction Manual
Table Of Contents
- 1、Unpacking Inspection
- 2、Packing List
- 3、Safety Precautions
- 4、Product Composition
- 5、Intended for Use
- 6、Classification of BP (Blood Pressure)
- 7、Product Parts
- 8、Preparation
- 9、Function Setting
- 10、How to take proper measurements
- ( 2 ) Attaching the arm cuff
- 1）Plug the arm cuff into your monitor by inserting t
- 2）Place your hand through the cuff loop. Pull the cu
- Note
- • The bottom edge of the arm cuff should be 0.79-1
- 3）Make sure that the air tube is positioned on the i
- 4）To take a measurement on your right arm
- When you take a measurement on your right arm, the
- (4) Taking a measurement
- (5) Memory function
- 11、Contraindications, Precautions, Warnings
- • DO NOT use this monitor on infants, toddlers, ch
- • DO NOT adjust medication based on readings from
- • DO NOT use this monitor on an injured arm or an
- • DO NOT apply the arm cuff on your arm while on a
- • DO NOT use this monitor in areas containing high
- • DO NOT use this monitor in oxygen rich environme
- • Consult with your physician before using this mo
- arterial sclerosis; poor perfusion; diabetes; preg
- • NEVER diagnose or treat yourself based on your r
- • To help avoid strangulation, keep the air tube a
- • This product contains small parts that may cause
- Stop using this monitor and consult with your phys
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • DO NOT take measurements more often than necessa
- • ONLY inflate the arm cuff when it is applied on
- • Remove the arm cuff if it does not start deflati
- • DO NOT use this monitor for any purpose other th
- • During measurement, make sure that no mobile dev
- • DO NOT disassemble or attempt to repair this mon
- • DO NOT use in a location where there is moisture
- • DO NOT use this monitor in a moving vehicle such
- • DO NOT drop or subject this monitor to strong sh
- • DO NOT use this monitor in places with high or l
- 12、Common Q & A on Blood Pressure
- 13、Abnormal Phenomena and Handling
- 14、Maintenance
- 15、Product Specification
6
9、Function Setting
(1) User mode
In standby mode, press the "SET" button to enter the user
group selection interface. Then press the "SET" button to
switch and select user groups.
(2) Year/month/Date/setting
In standby mode, press "SET" for about 3 seconds to enter
the date setting, and "year" will flash. Press "MEM" to adjust
to the desired year, and then press "SET" to confirm the
selection. When the "year" is set, it will automatically enter
the month setting. At this time, the "month" icon will flash.
You can switch to the desired value by pressing the "MEM"
button. Follow the same step to set "date", "hour", and
"minute".