Instruction Manual
Table Of Contents
- 1、Unpacking Inspection
- 2、Packing List
- 3、Safety Precautions
- 4、Product Composition
- 5、Intended for Use
- 6、Classification of BP (Blood Pressure)
- 7、Product Parts
- 8、Preparation
- 9、Function Setting
- 10、How to take proper measurements
- ( 2 ) Attaching the arm cuff
- 1）Plug the arm cuff into your monitor by inserting t
- 2）Place your hand through the cuff loop. Pull the cu
- Note
- • The bottom edge of the arm cuff should be 0.79-1
- 3）Make sure that the air tube is positioned on the i
- 4）To take a measurement on your right arm
- When you take a measurement on your right arm, the
- (4) Taking a measurement
- (5) Memory function
- 11、Contraindications, Precautions, Warnings
- • DO NOT use this monitor on infants, toddlers, ch
- • DO NOT adjust medication based on readings from
- • DO NOT use this monitor on an injured arm or an
- • DO NOT apply the arm cuff on your arm while on a
- • DO NOT use this monitor in areas containing high
- • DO NOT use this monitor in oxygen rich environme
- • Consult with your physician before using this mo
- arterial sclerosis; poor perfusion; diabetes; preg
- • NEVER diagnose or treat yourself based on your r
- • To help avoid strangulation, keep the air tube a
- • This product contains small parts that may cause
- Stop using this monitor and consult with your phys
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • DO NOT take measurements more often than necessa
- • ONLY inflate the arm cuff when it is applied on
- • Remove the arm cuff if it does not start deflati
- • DO NOT use this monitor for any purpose other th
- • During measurement, make sure that no mobile dev
- • DO NOT disassemble or attempt to repair this mon
- • DO NOT use in a location where there is moisture
- • DO NOT use this monitor in a moving vehicle such
- • DO NOT drop or subject this monitor to strong sh
- • DO NOT use this monitor in places with high or l
- 12、Common Q & A on Blood Pressure
- 13、Abnormal Phenomena and Handling
- 14、Maintenance
- 15、Product Specification
2. Take nRF Connect as an example, after entering the APP, turn on the Bluetooth, and fill in the filter Bluetooth name
30B Bluetooth version-Bluetooth function test method
1 2
1. Use a mobile phone to test the Bluetooth function, and download "nRF Connect" from an Android mobile phone,
as shown in the figure below
"AOJ-308" (Enxi customized version: RHO101) as shown in Figure 1, pull down to refresh, you can only see the
name "AOJ- 308B", if there are more than one, select the device with the strongest signal, and also strengthen
the RSSl to -50dBm filter, click CONNECT to connect, as shown in Figure 2 below:
3. Turn on the Bluetooth receiving service, as shown in Figure 3; measure once normally to check whether the
3 4
Bluetooth has received data, as shown in Figure 4;