Instruction Manual
Table Of Contents
- 1、Unpacking Inspection
- 2、Packing List
- 3、Safety Precautions
- 4、Product Composition
- 5、Intended for Use
- 6、Classification of BP (Blood Pressure)
- 7、Product Parts
- 8、Preparation
- 9、Function Setting
- 10、How to take proper measurements
- ( 2 ) Attaching the arm cuff
- 1）Plug the arm cuff into your monitor by inserting t
- 2）Place your hand through the cuff loop. Pull the cu
- Note
- • The bottom edge of the arm cuff should be 0.79-1
- 3）Make sure that the air tube is positioned on the i
- 4）To take a measurement on your right arm
- When you take a measurement on your right arm, the
- (4) Taking a measurement
- (5) Memory function
- 11、Contraindications, Precautions, Warnings
- • DO NOT use this monitor on infants, toddlers, ch
- • DO NOT adjust medication based on readings from
- • DO NOT use this monitor on an injured arm or an
- • DO NOT apply the arm cuff on your arm while on a
- • DO NOT use this monitor in areas containing high
- • DO NOT use this monitor in oxygen rich environme
- • Consult with your physician before using this mo
- arterial sclerosis; poor perfusion; diabetes; preg
- • NEVER diagnose or treat yourself based on your r
- • To help avoid strangulation, keep the air tube a
- • This product contains small parts that may cause
- Stop using this monitor and consult with your phys
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • DO NOT take measurements more often than necessa
- • ONLY inflate the arm cuff when it is applied on
- • Remove the arm cuff if it does not start deflati
- • DO NOT use this monitor for any purpose other th
- • During measurement, make sure that no mobile dev
- • DO NOT disassemble or attempt to repair this mon
- • DO NOT use in a location where there is moisture
- • DO NOT use this monitor in a moving vehicle such
- • DO NOT drop or subject this monitor to strong sh
- • DO NOT use this monitor in places with high or l
- 12、Common Q & A on Blood Pressure
- 13、Abnormal Phenomena and Handling
- 14、Maintenance
- 15、Product Specification
20
Q4. When will the measurement be better?
Please make measurement in the morning after you get up
to urinate or when your body and mood are in stable state. It
is better to make measurement at the same time every day.
Q5.Why the blood pressure value measured each time is
different?
1）When systole each time, the blood pressure will change to
some extent. For example, a person with the pulse of 70
beats per minute will have 100,800 blood pressure changes
every day. Because the blood pressure is constantly
changing, it is difficult to obtain the correct blood pressure
value by measurement only once. Please make measurement
for 2~3 times. The first measurement will generally be higher due
to nervousness or inadequate preparation, and then when
the second measurement, the nervous emotion will be slightly
alleviated, so generally, the second measurement will be
5mmHg-10mmHg (0.7kPa-1.3kPa) lower than the first time.
This will be more obvious for those with higher blood
pressure.
--When continuous measurement, please note that:
There might be extravasated blood because the arm is
compressed, resulting that the finger tip blood does not flow
smoothly, If you continue the measurement in case of
extravasated blood, you cannot obtain the correct measured
value. Loosen the arm band, raise your hand over the head,