Instruction Manual
Table Of Contents
- 1、Unpacking Inspection
- 2、Packing List
- 3、Safety Precautions
- 4、Product Composition
- 5、Intended for Use
- 6、Classification of BP (Blood Pressure)
- 7、Product Parts
- 8、Preparation
- 9、Function Setting
- 10、How to take proper measurements
- ( 2 ) Attaching the arm cuff
- 1）Plug the arm cuff into your monitor by inserting t
- 2）Place your hand through the cuff loop. Pull the cu
- Note
- • The bottom edge of the arm cuff should be 0.79-1
- 3）Make sure that the air tube is positioned on the i
- 4）To take a measurement on your right arm
- When you take a measurement on your right arm, the
- (4) Taking a measurement
- (5) Memory function
- 11、Contraindications, Precautions, Warnings
- • DO NOT use this monitor on infants, toddlers, ch
- • DO NOT adjust medication based on readings from
- • DO NOT use this monitor on an injured arm or an
- • DO NOT apply the arm cuff on your arm while on a
- • DO NOT use this monitor in areas containing high
- • DO NOT use this monitor in oxygen rich environme
- • Consult with your physician before using this mo
- arterial sclerosis; poor perfusion; diabetes; preg
- • NEVER diagnose or treat yourself based on your r
- • To help avoid strangulation, keep the air tube a
- • This product contains small parts that may cause
- Stop using this monitor and consult with your phys
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • DO NOT take measurements more often than necessa
- • ONLY inflate the arm cuff when it is applied on
- • Remove the arm cuff if it does not start deflati
- • DO NOT use this monitor for any purpose other th
- • During measurement, make sure that no mobile dev
- • DO NOT disassemble or attempt to repair this mon
- • DO NOT use in a location where there is moisture
- • DO NOT use this monitor in a moving vehicle such
- • DO NOT drop or subject this monitor to strong sh
- • DO NOT use this monitor in places with high or l
- 12、Common Q & A on Blood Pressure
- 13、Abnormal Phenomena and Handling
- 14、Maintenance
- 15、Product Specification
14
Note: If you feel uncomfortable during the measurement,
press the ON/OFF button immediately to stop
measure.When the air pressure is filled to a certain value,
the value on the display screen will slowly drop at a certain
speed, and the heartbeat symbol will flash. After the
measurement is completed, the systolic pressure, diastolic
pressure, and pulse measurements will be displayed on the
screen.
Note : consult your doctor if unexpected readings are
obtained.
(5) Memory function
1 ） This monitor stores 99 sets of memories of two users.
After each measurement, the monitor will automatically store