Instruction Manual
Table Of Contents
- 1、Unpacking Inspection
- 2、Packing List
- 3、Safety Precautions
- 4、Product Composition
- 5、Intended for Use
- 6、Classification of BP (Blood Pressure)
- 7、Product Parts
- 8、Preparation
- 9、Function Setting
- 10、How to take proper measurements
- ( 2 ) Attaching the arm cuff
- 1）Plug the arm cuff into your monitor by inserting t
- 2）Place your hand through the cuff loop. Pull the cu
- Note
- • The bottom edge of the arm cuff should be 0.79-1
- 3）Make sure that the air tube is positioned on the i
- 4）To take a measurement on your right arm
- When you take a measurement on your right arm, the
- (4) Taking a measurement
- (5) Memory function
- 11、Contraindications, Precautions, Warnings
- • DO NOT use this monitor on infants, toddlers, ch
- • DO NOT adjust medication based on readings from
- • DO NOT use this monitor on an injured arm or an
- • DO NOT apply the arm cuff on your arm while on a
- • DO NOT use this monitor in areas containing high
- • DO NOT use this monitor in oxygen rich environme
- • Consult with your physician before using this mo
- arterial sclerosis; poor perfusion; diabetes; preg
- • NEVER diagnose or treat yourself based on your r
- • To help avoid strangulation, keep the air tube a
- • This product contains small parts that may cause
- Stop using this monitor and consult with your phys
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • Consult with your physician before using this mo
- • DO NOT take measurements more often than necessa
- • ONLY inflate the arm cuff when it is applied on
- • Remove the arm cuff if it does not start deflati
- • DO NOT use this monitor for any purpose other th
- • During measurement, make sure that no mobile dev
- • DO NOT disassemble or attempt to repair this mon
- • DO NOT use in a location where there is moisture
- • DO NOT use this monitor in a moving vehicle such
- • DO NOT drop or subject this monitor to strong sh
- • DO NOT use this monitor in places with high or l
- 12、Common Q & A on Blood Pressure
- 13、Abnormal Phenomena and Handling
- 14、Maintenance
- 15、Product Specification
8
Thank you.
Your blood pressure is:
Systolic pressure xxx millimeter of mercury pillar.
Diastolic pressure xx millimeter of mercury pillar.
Your pulse is xx beats per minute.
Measuring result is normal.
Thank you.
Wish you a good health.
②If your blood pressure is not in normal range：
Measuring result is abnormal.
Your blood pressure is high/low
Could not measure your pulse at this time.
③Measuring error：
Error,(Mistake ),Please measure again
④Other operation：
Average Blood Pressure
Last time your blood pressure was xxx, your pulse was xx
Low battery, please replace the battery
Low battery, please charge in time