User's Manual

E3
+
transmitter supports memory function. You can save the wireless settings and
recall the setting later.
1. Press function button 4 until is displayed.
2. Save or load the settings
Press function button 3 corresponding to , and then press function button 1
corresponding to , the settings are saved (stored in the memory). Press function
button 2 corresponding to , the settings that were saved are set.
Clearing Transmitter Settings
You can return the settings for wireless shooting to their default settings.
Press function button 2 and 3 simultaneously for 2 seconds or longer, the transmitter
setting are cleared and the shooting mode returns to <ETTL>flash mode. Note that
even when the settings are cleared, the transmission channel, the wireless radio ID
and the C.Fn and P.Fn settings are not canceled.
III. MENU Functions
1.
FEB level
±3EV（in 1/3-stop increments）
2.
Flash exposure
compensation
±3EV（in 1/3-stop increments）
3.
C.Fn function C.Fn -01 to 22
4.
Flash Ratio
ETTL
RATIO A:B C
RATIO A:B
RATIO OFF
A:B ratio
setting:
8:1 to 1:8, in
1/2-stop
increments
M/Multi
RATIO A:B:C
RATIO A:B
RATIO OFF
5.
Scan function
Scan the radio reception status and set the
master unit’s transmission channel
automatically or manually.
6.
Wireless radio ID 0000-9999
7.
Transmission
Channel
Ch.1-Ch.15and Auto
8.
Memory Function
Save the present setting
Load the settings that were saved
Back to shooting-ready state
9.
Sync Mode
Enable High Speed Sync
No display First Curtain Sync