User's Manual

Note: When is displayed, please replace the batteries with new ones.
USB port
The firmware of E3
+
transmitter can be upgraded via the USB port, so as to adjust its
parameter and extend its compatibility with cameras to come in the future.
1.1 Connect the USB cable to the computer and the other end of the USB cable to
E3+ transmitters USB port. A mobile device icon will be displayed on the computer
when successfully connected.
1.2 Double click to start the upgrade software. The upgrade software can be used to
check version info, and upgrade the Base software, RF software and Icon.
Click "Version" icon, the current version information of the connected E3
+
transmitter
will be displayed in the software window.
Click "Base software" icon, locate and double click on the FDS file from the pop-out
window. Then it starts loading the new firmware.
Click "RF software" icon, locate and double click on the RFC file from the pop-out
window. Then it starts loading the new firmware.
Click "Icon" icon, locate and double click on the FIF file from the pop-out window.
Then it starts loading the new firmware.
1.3 The status of the upgrade will be displayed in the process bar. When completed,
an Updata OKwill be displayed at the bottom of the upgrade software window, and
a Download OK will be displayed on the transmitters LCD screen. Upon
completion, disconnect the USB cable and restart the E3
+
transmitter.
Note:
Please ensure stable power supply when attempting to upgrade the E3
+
transmitter..
Loss of computer power during the upgrade process could fail the upgrading.
Check Version info on E3
+
transmitter
You can check the present version information on E3
+
transmitter: while pressing the
power button to turn on the transmitter, press the flash <MODE> button simultaneously
until the version info is displayed on the LCD screen.
<>: Charge Lamp/Test Flash Button
1. The charge lamp lights when the wireless shooting (slave) is ready.
2. During wireless shooting, master units charge up will be lit when all slave units
are fully charged.
3. During wireless shooting, you can press the transmitters charge lamp (test flash
button to fire a test flash.